Then shut off the cold water valve at the top of the tank and attach a garden hose to the existing drain valve and route it to a floor drain.
Cleaning water heater tank.
This water will help dislodge any additional sediment that may have been inside your tank.
Use this guide to flush your water heater.
Run the hose end to a basin where you can collect hot water.
Shut off the gas or electricity to the water heater and open a hot water faucet and let it run full blast for about 10 minutes to reduce the water temperature in the tank.
Once the water has drained close the valve.
Open the drain valve after unscrewing the water supply line and allow sufficient time for the water to drain out of the heater into the basin.
To clean the sediment out of a water heater follow these steps.
Be sure to turn off the power to the water heater and the cold water inlet valve before you begin any repairs.
Rotate the wand around the tank so it sprays each wall of the tank.
Use the crevice attachment to clean underneath the tank around the pipes and behind the hot water heater.
Your water heater will operate more efficiently and this will usually extend the life of the heater.
Press down on the wand s handle to shoot the water inside the tank.
Unscrew the cold water supply line at the top of the water heater and remove the nipple screwed into the cold water port.
Take a water hose and attach it to the drain valve.
Pour clean water to your water heater through the funnel based on the size of your heater and the cleaning product s directions.
For a 40 gallon tank you will typically pour 2 gallons of clean.
Water heaters should be flushed every one to three years depending on the model and water source.
Step by step instructions for flushing the sediment from a water heater.
Storage tank water heaters require little maintenance and are less expensive than tankless water heaters.
Push the end of the wand into the port at the bottom of the water heater tank and turn on your hose.
Let the drain valve run for a few minutes until the water exiting from the hose is clear.
Step 3 wipe the hot water heater down with a dry cloth to get rid of as much dry dirt as possible.
This helps to control the buildup of mineral deposits.
Tank water heaters vs.
If there is a thick layer of dust or dirt on your hot water heater use a shop vac to take off as much dust as possible.
On the downside they use more energy.
Then turn the cold water supply off once more.
Spray the inside of the tank with the cleaning wand.